u-boot/drivers/rtc/ht1380.c

330 lines
6.5 KiB
C
Raw Normal View History

// SPDX-License-Identifier: GPL-2.0+
/*
* Holtek HT1380/HT1381 Serial Timekeeper Chip
*
* Communication with the chip is vendor-specific.
* It is done via 3 GPIO pins: reset, clock, and data.
* Describe in .dts this way:
*
* rtc {
* compatible = "holtek,ht1380";
* rst-gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
* clk-gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
* dat-gpios = <&gpio 21 GPIO_ACTIVE_HIGH>;
* };
*
*/
#include <common.h>
#include <dm.h>
#include <rtc.h>
#include <bcd.h>
#include <asm/gpio.h>
#include <linux/delay.h>
struct ht1380_priv {
struct gpio_desc rst_desc;
struct gpio_desc clk_desc;
struct gpio_desc dat_desc;
};
enum registers {
SEC,
MIN,
HOUR,
MDAY,
MONTH,
WDAY,
YEAR,
WP,
N_REGS
};
enum hour_mode {
AMPM_MODE = 0x80, /* RTC is in AM/PM mode */
PM_NOW = 0x20, /* set if PM, clear if AM */
};
static const int BURST = 0xbe;
static const int READ = 1;
static void ht1380_half_period_delay(void)
{
/*
* Delay for half a period. 1 us complies with the 500 KHz maximum
* input serial clock limit given by the datasheet.
*/
udelay(1);
}
static int ht1380_send_byte(struct ht1380_priv *priv, int byte)
{
int ret;
for (int bit = 0; bit < 8; bit++) {
ret = dm_gpio_set_value(&priv->dat_desc, byte >> bit & 1);
if (ret)
break;
ht1380_half_period_delay();
ret = dm_gpio_set_value(&priv->clk_desc, 1);
if (ret)
break;
ht1380_half_period_delay();
ret = dm_gpio_set_value(&priv->clk_desc, 0);
if (ret)
break;
}
return ret;
}
/*
* Leave reset state. The transfer operation can then be started.
*/
static int ht1380_reset_off(struct ht1380_priv *priv)
{
const unsigned int T_CC = 4; /* us, Reset to Clock Setup */
int ret;
/*
* Leave RESET state.
* Make sure we make the minimal delay required by the datasheet.
*/
ret = dm_gpio_set_value(&priv->rst_desc, 0);
udelay(T_CC);
return ret;
}
/*
* Enter reset state. Completes the transfer operation.
*/
static int ht1380_reset_on(struct ht1380_priv *priv)
{
const unsigned int T_CWH = 4; /* us, Reset Inactive Time */
int ret;
/*
* Enter RESET state.
* Make sure we make the minimal delay required by the datasheet.
*/
ret = dm_gpio_set_value(&priv->rst_desc, 1);
udelay(T_CWH);
return ret;
}
static int ht1380_rtc_get(struct udevice *dev, struct rtc_time *tm)
{
struct ht1380_priv *priv = dev_get_priv(dev);
int ret, i, bit, reg[N_REGS];
ret = dm_gpio_set_value(&priv->clk_desc, 0);
if (ret)
return ret;
ret = dm_gpio_set_dir_flags(&priv->dat_desc, GPIOD_IS_OUT);
if (ret)
return ret;
ret = ht1380_reset_off(priv);
if (ret)
goto exit;
ret = ht1380_send_byte(priv, BURST + READ);
if (ret)
goto exit;
ret = dm_gpio_set_dir_flags(&priv->dat_desc, GPIOD_IS_IN);
if (ret)
goto exit;
for (i = 0; i < N_REGS; i++) {
reg[i] = 0;
for (bit = 0; bit < 8; bit++) {
ht1380_half_period_delay();
ret = dm_gpio_set_value(&priv->clk_desc, 1);
if (ret)
goto exit;
ht1380_half_period_delay();
reg[i] |= dm_gpio_get_value(&priv->dat_desc) << bit;
ret = dm_gpio_set_value(&priv->clk_desc, 0);
if (ret)
goto exit;
}
}
ret = -EINVAL;
/* Correctness check: some bits are always zero */
if (reg[MIN] & 0x80 || reg[HOUR] & 0x40 || reg[MDAY] & 0xc0 ||
reg[MONTH] & 0xe0 || reg[WDAY] & 0xf8 || reg[WP] & 0x7f)
goto exit;
/* Correctness check: some registers are always non-zero */
if (!reg[MDAY] || !reg[MONTH] || !reg[WDAY])
goto exit;
tm->tm_sec = bcd2bin(reg[SEC]);
tm->tm_min = bcd2bin(reg[MIN]);
if (reg[HOUR] & AMPM_MODE) {
/* AM-PM Mode, range is 01-12 */
tm->tm_hour = bcd2bin(reg[HOUR] & 0x1f) % 12;
if (reg[HOUR] & PM_NOW) {
/* it is PM (otherwise AM) */
tm->tm_hour += 12;
}
} else {
/* 24-hour Mode, range is 0-23 */
tm->tm_hour = bcd2bin(reg[HOUR]);
}
tm->tm_mday = bcd2bin(reg[MDAY]);
tm->tm_mon = bcd2bin(reg[MONTH]);
tm->tm_year = 2000 + bcd2bin(reg[YEAR]);
tm->tm_wday = bcd2bin(reg[WDAY]) - 1;
tm->tm_yday = 0;
tm->tm_isdst = 0;
ret = 0;
exit:
ht1380_reset_on(priv);
return ret;
}
static int ht1380_write_protection_off(struct ht1380_priv *priv)
{
int ret;
const int PROTECT = 0x8e;
ret = ht1380_reset_off(priv);
if (ret)
return ret;
ret = ht1380_send_byte(priv, PROTECT);
if (ret)
return ret;
ret = ht1380_send_byte(priv, 0); /* WP bit is 0 */
if (ret)
return ret;
return ht1380_reset_on(priv);
}
static int ht1380_rtc_set(struct udevice *dev, const struct rtc_time *tm)
{
struct ht1380_priv *priv = dev_get_priv(dev);
int ret, i, reg[N_REGS];
ret = dm_gpio_set_value(&priv->clk_desc, 0);
if (ret)
return ret;
ret = dm_gpio_set_dir_flags(&priv->dat_desc, GPIOD_IS_OUT);
if (ret)
goto exit;
ret = ht1380_write_protection_off(priv);
if (ret)
goto exit;
reg[SEC] = bin2bcd(tm->tm_sec);
reg[MIN] = bin2bcd(tm->tm_min);
reg[HOUR] = bin2bcd(tm->tm_hour);
reg[MDAY] = bin2bcd(tm->tm_mday);
reg[MONTH] = bin2bcd(tm->tm_mon);
reg[WDAY] = bin2bcd(tm->tm_wday) + 1;
reg[YEAR] = bin2bcd(tm->tm_year - 2000);
reg[WP] = 0x80; /* WP bit is 1 */
ret = ht1380_reset_off(priv);
if (ret)
goto exit;
ret = ht1380_send_byte(priv, BURST);
for (i = 0; i < N_REGS && ret; i++)
ret = ht1380_send_byte(priv, reg[i]);
exit:
ht1380_reset_on(priv);
return ret;
}
static int ht1380_probe(struct udevice *dev)
{
int ret;
struct ht1380_priv *priv;
priv = dev_get_priv(dev);
if (!priv)
return -EINVAL;
ret = gpio_request_by_name(dev, "rst-gpios", 0,
&priv->rst_desc, GPIOD_IS_OUT);
if (ret)
goto fail_rst;
ret = gpio_request_by_name(dev, "clk-gpios", 0,
&priv->clk_desc, GPIOD_IS_OUT);
if (ret)
goto fail_clk;
ret = gpio_request_by_name(dev, "dat-gpios", 0,
&priv->dat_desc, 0);
if (ret)
goto fail_dat;
ret = ht1380_reset_on(priv);
if (ret)
goto fail;
return 0;
fail:
dm_gpio_free(dev, &priv->dat_desc);
fail_dat:
dm_gpio_free(dev, &priv->clk_desc);
fail_clk:
dm_gpio_free(dev, &priv->rst_desc);
fail_rst:
return ret;
}
static int ht1380_remove(struct udevice *dev)
{
struct ht1380_priv *priv = dev_get_priv(dev);
dm_gpio_free(dev, &priv->rst_desc);
dm_gpio_free(dev, &priv->clk_desc);
dm_gpio_free(dev, &priv->dat_desc);
return 0;
}
static const struct rtc_ops ht1380_rtc_ops = {
.get = ht1380_rtc_get,
.set = ht1380_rtc_set,
};
static const struct udevice_id ht1380_rtc_ids[] = {
{ .compatible = "holtek,ht1380" },
{ }
};
U_BOOT_DRIVER(rtc_ht1380) = {
.name = "rtc-ht1380",
.id = UCLASS_RTC,
.probe = ht1380_probe,
.remove = ht1380_remove,
.of_match = ht1380_rtc_ids,
.ops = &ht1380_rtc_ops,
.priv_auto = sizeof(struct ht1380_priv),
};