mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-14 08:57:58 +00:00
209 lines
6.7 KiB
Text
209 lines
6.7 KiB
Text
|
Intel x86 PINCTRL/GPIO controller
|
||
|
|
||
|
Pin-muxing on broadwell devices can be described with a node for the PINCTRL
|
||
|
master node and a set of child nodes for each required pin state on the SoC.
|
||
|
These pin states use phandles and are referred to but a configuration section
|
||
|
which lists all pins in the device.
|
||
|
|
||
|
The PINCTRL master node requires the following properties:
|
||
|
- compatible : "intel,x86-broadwell-pinctrl"
|
||
|
|
||
|
Pin state nodes must be sub-nodes of the pinctrl master node. The must have
|
||
|
a phandle. They can contain the following optional properties:
|
||
|
- mode-gpio - forces the pin into GPIO mode
|
||
|
- output-value - sets the default output value of the GPIO, 0 (low, default)
|
||
|
or 1 (high)
|
||
|
- direction - sets the direction of the gpio, either PIN_INPUT (default)
|
||
|
or PIN_OUTPUT
|
||
|
- invert - the input pin is inverted
|
||
|
- trigger - sets the trigger type, either TRIGGER_EDGE (default) or
|
||
|
TRIGGER_LEVEL
|
||
|
- sense-disable - the input state sense is disabled
|
||
|
- owner 0 sets the owner of the pin, either OWNER_ACPI (default) or
|
||
|
ONWER_GPIO
|
||
|
- route - sets whether the pin is routed, either PIRQ_APIC_MASK or
|
||
|
PIRQ_APIC_ROUTE
|
||
|
- irq-enable - the interrupt is enabled
|
||
|
- reset-rsmrst - the pin will only be reset by RSMRST
|
||
|
- pirq-apic - the pin will be routed to the IOxAPIC
|
||
|
|
||
|
The first pin state will be the default, so pins without a configuration will
|
||
|
use that.
|
||
|
|
||
|
The pin configuration node is also a sub-node of the pinctrl master node, but
|
||
|
does not have a phandle. It has a single property:
|
||
|
|
||
|
- config - configuration to use for each pin. Each entry has of 3 cells:
|
||
|
- GPIO number (0..94)
|
||
|
- phandle of configuration (above)
|
||
|
- interrupt number (0..15)
|
||
|
|
||
|
There should be one entry for each pin (i.e. 95 entries).
|
||
|
But missing pins will receive the default configuration.
|
||
|
|
||
|
Example:
|
||
|
|
||
|
pch_pinctrl {
|
||
|
compatible = "intel,x86-broadwell-pinctrl";
|
||
|
|
||
|
/* Put this first: it is the default */
|
||
|
gpio_unused: gpio-unused {
|
||
|
mode-gpio;
|
||
|
direction = <PIN_INPUT>;
|
||
|
owner = <OWNER_GPIO>;
|
||
|
sense-disable;
|
||
|
};
|
||
|
|
||
|
gpio_acpi_sci: acpi-sci {
|
||
|
mode-gpio;
|
||
|
direction = <PIN_INPUT>;
|
||
|
invert;
|
||
|
route = <ROUTE_SCI>;
|
||
|
};
|
||
|
|
||
|
gpio_acpi_smi: acpi-smi {
|
||
|
mode-gpio;
|
||
|
direction = <PIN_INPUT>;
|
||
|
invert;
|
||
|
route = <ROUTE_SMI>;
|
||
|
};
|
||
|
|
||
|
gpio_input: gpio-input {
|
||
|
mode-gpio;
|
||
|
direction = <PIN_INPUT>;
|
||
|
owner = <OWNER_GPIO>;
|
||
|
};
|
||
|
|
||
|
gpio_input_invert: gpio-input-invert {
|
||
|
mode-gpio;
|
||
|
direction = <PIN_INPUT>;
|
||
|
owner = <OWNER_GPIO>;
|
||
|
invert;
|
||
|
};
|
||
|
|
||
|
gpio_native: gpio-native {
|
||
|
};
|
||
|
|
||
|
gpio_out_high: gpio-out-high {
|
||
|
mode-gpio;
|
||
|
direction = <PIN_OUTPUT>;
|
||
|
output-value = <1>;
|
||
|
owner = <OWNER_GPIO>;
|
||
|
sense-disable;
|
||
|
};
|
||
|
|
||
|
gpio_out_low: gpio-out-low {
|
||
|
mode-gpio;
|
||
|
direction = <PIN_OUTPUT>;
|
||
|
output-value = <0>;
|
||
|
owner = <OWNER_GPIO>;
|
||
|
sense-disable;
|
||
|
};
|
||
|
|
||
|
gpio_pirq: gpio-pirq {
|
||
|
mode-gpio;
|
||
|
direction = <PIN_INPUT>;
|
||
|
owner = <OWNER_GPIO>;
|
||
|
pirq-apic = <PIRQ_APIC_ROUTE>;
|
||
|
};
|
||
|
|
||
|
soc_gpio@0 {
|
||
|
config =
|
||
|
<0 &gpio_unused 0>, /* unused */
|
||
|
<1 &gpio_unused 0>, /* unused */
|
||
|
<2 &gpio_unused 0>, /* unused */
|
||
|
<3 &gpio_unused 0>, /* unused */
|
||
|
<4 &gpio_native 0>, /* native: i2c0_sda_gpio4 */
|
||
|
<5 &gpio_native 0>, /* native: i2c0_scl_gpio5 */
|
||
|
<6 &gpio_native 0>, /* native: i2c1_sda_gpio6 */
|
||
|
<7 &gpio_native 0>, /* native: i2c1_scl_gpio7 */
|
||
|
<8 &gpio_acpi_sci 0>, /* pch_lte_wake_l */
|
||
|
<9 &gpio_input_invert 0>,/* trackpad_int_l (wake) */
|
||
|
<10 &gpio_acpi_sci 0>, /* pch_wlan_wake_l */
|
||
|
<11 &gpio_unused 0>, /* unused */
|
||
|
<12 &gpio_unused 0>, /* unused */
|
||
|
<13 &gpio_pirq 3>, /* trackpad_int_l (pirql) */
|
||
|
<14 &gpio_pirq 4>, /* touch_int_l (pirqm) */
|
||
|
<15 &gpio_unused 0>, /* unused (strap) */
|
||
|
<16 &gpio_input 0>, /* pch_wp */
|
||
|
<17 &gpio_unused 0>, /* unused */
|
||
|
<18 &gpio_unused 0>, /* unused */
|
||
|
<19 &gpio_unused 0>, /* unused */
|
||
|
<20 &gpio_native 0>, /* pcie_wlan_clkreq_l */
|
||
|
<21 &gpio_out_high 0>, /* pp3300_ssd_en */
|
||
|
<22 &gpio_unused 0>, /* unused */
|
||
|
<23 &gpio_out_low 0>, /* pp3300_autobahn_en */
|
||
|
<24 &gpio_unused 0>, /* unused */
|
||
|
<25 &gpio_input 0>, /* ec_in_rw */
|
||
|
<26 &gpio_unused 0>, /* unused */
|
||
|
<27 &gpio_acpi_sci 0>, /* pch_wake_l */
|
||
|
<28 &gpio_unused 0>, /* unused */
|
||
|
<29 &gpio_unused 0>, /* unused */
|
||
|
<30 &gpio_native 0>, /* native: pch_suswarn_l */
|
||
|
<31 &gpio_native 0>, /* native: acok_buf */
|
||
|
<32 &gpio_native 0>, /* native: lpc_clkrun_l */
|
||
|
<33 &gpio_native 0>, /* native: ssd_devslp */
|
||
|
<34 &gpio_acpi_smi 0>, /* ec_smi_l */
|
||
|
<35 &gpio_acpi_smi 0>, /* pch_nmi_dbg_l (route in nmi_en) */
|
||
|
<36 &gpio_acpi_sci 0>, /* ec_sci_l */
|
||
|
<37 &gpio_unused 0>, /* unused */
|
||
|
<38 &gpio_unused 0>, /* unused */
|
||
|
<39 &gpio_unused 0>, /* unused */
|
||
|
<40 &gpio_native 0>, /* native: pch_usb1_oc_l */
|
||
|
<41 &gpio_native 0>, /* native: pch_usb2_oc_l */
|
||
|
<42 &gpio_unused 0>, /* wlan_disable_l */
|
||
|
<43 &gpio_out_high 0>, /* pp1800_codec_en */
|
||
|
<44 &gpio_unused 0>, /* unused */
|
||
|
<45 &gpio_acpi_sci 0>, /* dsp_int - codec wake */
|
||
|
<46 &gpio_pirq 6>, /* hotword_det_l_3v3 (pirqo) - codec irq */
|
||
|
<47 &gpio_out_low 0>, /* ssd_reset_l */
|
||
|
<48 &gpio_unused 0>, /* unused */
|
||
|
<49 &gpio_unused 0>, /* unused */
|
||
|
<50 &gpio_unused 0>, /* unused */
|
||
|
<51 &gpio_unused 0>, /* unused */
|
||
|
<52 &gpio_input 0>, /* sim_det */
|
||
|
<53 &gpio_unused 0>, /* unused */
|
||
|
<54 &gpio_unused 0>, /* unused */
|
||
|
<55 &gpio_unused 0>, /* unused */
|
||
|
<56 &gpio_unused 0>, /* unused */
|
||
|
<57 &gpio_out_high 0>, /* codec_reset_l */
|
||
|
<58 &gpio_unused 0>, /* unused */
|
||
|
<59 &gpio_out_high 0>, /* lte_disable_l */
|
||
|
<60 &gpio_unused 0>, /* unused */
|
||
|
<61 &gpio_native 0>, /* native: pch_sus_stat */
|
||
|
<62 &gpio_native 0>, /* native: pch_susclk */
|
||
|
<63 &gpio_native 0>, /* native: pch_slp_s5_l */
|
||
|
<64 &gpio_unused 0>, /* unused */
|
||
|
<65 &gpio_input 0>, /* ram_id3 */
|
||
|
<66 &gpio_input 0>, /* ram_id3_old (strap) */
|
||
|
<67 &gpio_input 0>, /* ram_id0 */
|
||
|
<68 &gpio_input 0>, /* ram_id1 */
|
||
|
<69 &gpio_input 0>, /* ram_id2 */
|
||
|
<70 &gpio_unused 0>, /* unused */
|
||
|
<71 &gpio_native 0>, /* native: modphy_en */
|
||
|
<72 &gpio_unused 0>, /* unused */
|
||
|
<73 &gpio_unused 0>, /* unused */
|
||
|
<74 &gpio_unused 0>, /* unused */
|
||
|
<75 &gpio_unused 0>, /* unused */
|
||
|
<76 &gpio_unused 0>, /* unused */
|
||
|
<77 &gpio_unused 0>, /* unused */
|
||
|
<78 &gpio_unused 0>, /* unused */
|
||
|
<79 &gpio_unused 0>, /* unused */
|
||
|
<80 &gpio_unused 0>, /* unused */
|
||
|
<81 &gpio_unused 0>, /* unused */
|
||
|
<82 &gpio_native 0>, /* native: ec_rcin_l */
|
||
|
<83 &gpio_native 0>, /* gspi0_cs */
|
||
|
<84 &gpio_native 0>, /* gspi0_clk */
|
||
|
<85 &gpio_native 0>, /* gspi0_miso */
|
||
|
<86 &gpio_native 0>, /* gspi0_mosi (strap) */
|
||
|
<87 &gpio_unused 0>, /* unused */
|
||
|
<88 &gpio_unused 0>, /* unused */
|
||
|
<89 &gpio_out_high 0>, /* pp3300_sd_en */
|
||
|
<90 &gpio_unused 0>, /* unused */
|
||
|
<91 &gpio_unused 0>, /* unused */
|
||
|
<92 &gpio_unused 0>, /* unused */
|
||
|
<93 &gpio_unused 0>, /* unused */
|
||
|
<94 &gpio_unused 0 >; /* unused */
|
||
|
};
|
||
|
};
|